Manual T Drill for Copper 15 - 42mm

Manual T Drill for Copper 15 - 42mm

Manual Tee- Extractor For Copper

Manual T Drill for Copper 15 - 42mm

Tee Extractor.

Operators Manual

Operators Manual

Recommended PPE

Tee Extractor.

Additional Information

Rothenberger Tee-Extractor Set

Capacity: 15-42mm

Type Of Set: Manual

Standard Equipment:
1 X Tee-Extractor Set, Inc: 1 X Unidrill,
1x Ratchet, 1 X Cam Pincer,
1 X Extractors, 15-42mm.

,

Related Products

Hire

T60 110v T Drill 15 - 54mm

T60 110v T Drill 15 - 54mm

The T-DRILL T-60 is a portable tee forming machine for copper tubes. It is an ideal solution for making tee joints in main run tube.

Hire

ND-54 Tube End Notcher

ND-54 Tube End Notcher

ND-54 Tube End Notcher is used for cutting and dimpling the branched tube ends to enable the best possible flow characteristics. This is an accessory to the T60 T-Drill.

T60 110v T Drill 15 - 54mm

T60 110v T Drill 15 - 54mm

The T-DRILL T-60 is a portable tee forming machine for copper tubes. It is an ideal solution for making tee joints in main run tube.

ND-54 Tube End Notcher

ND-54 Tube End Notcher

ND-54 Tube End Notcher is used for cutting and dimpling the branched tube ends to enable the best possible flow characteristics. This is an accessory to the T60 T-Drill.

Tubela 15-54mm Ratchet Assisted Copper Bender

Tubela 15-54mm Ratchet Assisted Copper Bender

For all your tube bending requirements for copper, stainless steel, aluminium, conduit, mild steel tube. Not suitable for use with Litex tube. Litex tube will split and crack if bending is attempted.

Ridgid Hydraulic Pipe Bender 1/2 Inch to 2 Inch

Ridgid Hydraulic Pipe Bender 1/2 Inch to 2 Inch

Versatile, portable benders, ideal for on-site bending as well as machine construction, boiler making and industrial applications in general.

Ridgid Stud Cutter 10MM

Ridgid Stud Cutter 10MM

The 1390 Threaded Rod Cutter is designed to cut threaded rods used to hang pipes for air conditioning, sprinkler installations and other lightweight frames from the ceiling. Makes clean cuts without damaging thread.

8 Inch Axxair Cutter C/W Bench

8 Inch Axxair Cutter C/W Bench

The Axxair cutter offers cutting without tube deformation and is ideal for thin wall stainless tubes and pipes. It provides a cut of quality geometry leaving a good surface condition.

Back to Pipe Fitting

Back to All Hire Equipment

Over 30 YearsExperience & Knowledge

Fast ShippingAcross UK Mainland

Wide & ExtensiveSelection of Tools